There Is Not A Trace Of Doubt That You Well Know That There Are 24 Hours In A Day. Wait, Can You Just Imagine If You Did Not? For Sure, Your Companions Would Be Patiently Bearing With Your Ignorance. Is Not That A Big Slap On Your Face? After All The Years Of Your Existence, Having Been Educated Well But, Not Knowing Such Essential Fact Can Be Very Frustrating. The First Step Is To Get Acquainted With The Clock Parts. As A Lot Of People Usually Say, You Have To Familiarize The Interior Before Going To The Borders. The Initial Thing That You Will See Is The Face Where There Are Numbers With Two Pointers Called Hands That Are Both Long And Short.Typical Clock Parts Have Digits From 1- 12 Especially Those That Will Be Mounted On The Wall Or Worn On The Wrist. Each Consists An Hour. There Are Some That Have Marks But There Are Also Some That Do Not Have Any. Of Course, It Is Very Beneficial To The User Since The More It Will Be Easy. However, There Is Not Much Sweat When Yours Does Not Have Any Since All Of Them Are Consistent, It Is Just A Matter Of Figuring It Out The Right Way. It Will Rotate In A Circular Motion If The Frame Is Circle Or Rectangular Motion If The Frame Is Rectangle. It Is Sort Of Similar To The Water Where It Will Take The Shape Of Its Container. As Mentioned Earlier, One Of The Clock Parts Are Long And Short Pointers Called As Hands. The Little Refers To The Hours Like When It Positions To Number Six, It Means That Is 6:00. As For The Bigger, It Indicates Minutes Like When It Is Directing To Number 3, It Means 15 Minutes; Number 6, It Means 30 Minutes And Number 9, It Means 45 Minutes. There Is Also For The Seconds Albeit, It Is Very Rare. Not All That Are Mounted On The Walls Or Worn On The Wrists Have It. If You Notice One Where It Just Continues To Turn And Does Not Stop, That Is It Already. Moving To The Technical Side Of Clock Parts, It Includes The Chime Hammer, Tapered Pins, Hand Washers, Pendulum Nuts, Gong Wire, Spiral Finial, Brass Leaf, Clip Assortment, Split Washers, Mixed Bushings, Screw Variety And Mixed Bobs, Among The Others. Chime Hammer Is Used To Replace The Hammers That Are Missing. The Wire Enters Through It Which Is Then Tightened By The Screw On The Tip. Tapered Pins Are Available In Various Diameters Of Brass And Steel. It Holds The Dial To A Movement.Screw Variety Is Smaller Which Usually Comes In A Pack Of 100. It Is Much The Same To The Machine Type Where It Has A Flat End.Mixed Bobs Are For Pendulum Used In Mantle Types. The Two Weights Are Based On Its Thickness And Weight.
